net: ravb: Detect PHY correctly

The order of parameters passed to the phy_connect() was wrong.
Moreover, only PHY address 0 was used. Replace this with code
capable of detecting the PHY address.

Signed-off-by: Marek Vasut <[email protected]>
Cc: Joe Hershberger <[email protected]>
Cc: Nobuhiro Iwamatsu <[email protected]>
Acked-by: Joe Hershberger <[email protected]>
Signed-off-by: Nobuhiro Iwamatsu <[email protected]>

diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c
index 7f0e2568b76b2c6225c3f722262a48a5699a5f98..ce0eacceb60adcfd51533f6bed972c0d3dc5d047 100644 (file)
--- a/drivers/net/ravb.c
+++ b/drivers/net/ravb.c
@@ -298,13 +298,14 @@ static int ravb_phy_config(struct udevice *dev)
        struct ravb_priv *eth = dev_get_priv(dev);
        struct eth_pdata *pdata = dev_get_platdata(dev);
        struct phy_device *phydev;
-       int reg;
+       int mask = 0xffffffff, reg;
 
-       phydev = phy_connect(eth->bus, pdata->phy_interface,
-                            dev, PHY_INTERFACE_MODE_RGMII_ID);
+       phydev = phy_find_by_mask(eth->bus, mask, pdata->phy_interface);
        if (!phydev)
                return -ENODEV;
 
+       phy_connect_dev(phydev, dev);
+
        eth->phydev = phydev;
 
        /* 10BASE is not supported for Ethernet AVB MAC */